
Successfully resists drones: Admiral Tributs ASW ship conducts exercises in the Sea of Japan
30-mm AK-630M artillery systems were used to perform the tasks

30-mm AK-630M artillery systems were used to perform the tasks

The train will run on the Big Circle Line for six months

New lithium extraction method does not require expensive installations

The composite can be used in modern combustion equipment

The vessel is designed for the delivery of goods and passengers in difficult terrain

The spacecraft will have a service life of 15 years

Special vehicles for viticulture and demining will be created on the basis of the "Dontech" tractor

M1.5 class flare occurred in active solar center No. 4232

Germanium wafers have a higher efficiency compared to silicon ones - about 30%

Tu-142MZ made five sorties and completed more than 15 dockings with Il-78M

New building material reduces heat loss inside premises by 15% - 25%

The station's operation is supported by emergency diesel generators, but everything is currently under control

The average fuel consumption of the truck tractor is 28.5 liters

Locomotive to reach maximum speed of 400 km/h during testing

In 2026, the new engine will appear on the Lada Niva Legend

The PV300VD project cruise ship was launched in 2019, but construction has been delayed

The artificial island of Krivaya Damba is located in the port area

Mass production of the aircraft will start in 2027

The icebreaker of project 10510 is planned to be completed by 2030

Russian Railways May Appeal the Decision in the Fourth Court of Appeal

The cars received a new six-speed manual transmission

The company is already building the first ferry for transporting tractors and equipment

The advantages of the development are low cost and environmental friendliness

Among the new projects are two pilot boats and a hybrid yacht

Russia uses the Luch-Olimp satellites for reconnaissance

Coverage radius of the anti-drone system - up to 5 km

Technology has undergone successful testing

The method takes into account the physical and geometric properties of composites

It is planned to print tens of thousands of eardrums a year on a 3D bioprinter