The United Aircraft Corporation (UAC) has for the first time shown forged ingots made of titanium alloy. This material is used to make individual parts for domestic aircraft.
Before starting forging, titanium is heated to a temperature of 950°C. After that, preliminary heat treatment takes place.
Then the blanks are sent to the machining shop, where aircraft parts are made from them.
Earlier, www1.ru also reported that titanium parts for the wing of the new MS-21 aircraft began to be produced in Ulyanovsk
Read more materials:
The latest SJ-100, MS-21 and Tu-214 aircraft will receive satellite WiFi on board
The latest MS-21-300 aircraft consumes half the kerosene of the Tu-154M
Now on home
Buyers are increasingly receiving empty packages instead of unusual plants
New approaches will reduce the cardiotoxicity of chemotherapy and the risk of myocardial infarction
Resources with priority access stopped opening, the number of complaints exceeded 1300 in an hour
Domestic 15-inch Three-Blade Propellers Are Already Working on the Front Lines
The peak occurred during daylight hours, the auroras may fade by night
The Prosecutor General's Office considered the charges not based on factual evidence
The Far Eastern Training Ground is the First to Use a Combination of Ground and Air Scanning
The ship was successfully launched into orbit
New development allows combining striking elements of different geometries in one shot
Requirements for tire seasonality are established by the technical regulations of the Customs Union
The actor expressed concern about the impact of neural networks on cinema